11. Apply a small amount of grease to the axle on the left

11

 

 

 

Crank Arm (6).

 

 

 

 

 

 

 

Slide a Nylon Washer (11) and the Left Pedal Arm (3)

 

 

 

 

onto the axle on the left Crank Arm (6). Note: It may be

 

 

 

 

helpful to use a rubber mallet to tap these parts on. Be

 

 

Grease

 

careful not to confuse the Left Pedal Arm with the

 

 

 

 

3

 

 

Right Pedal Arm (not shown); look at the position

 

6

 

of the round tube to identify the Left Pedal Arm.

 

 

 

 

 

 

 

Next, tap a 3/4Ó Axle Cap (61) onto the axle.

 

 

 

 

Attach the Right Pedal Arm (not shown) in the same way.

 

61

11

 

 

 

 

 

 

 

 

Round Tube

 

12. Refer to the inset drawing. Apply a small amount of

12

 

 

 

the included Teflon¨ lubricant to a paper towel; rub a

 

 

 

 

 

 

7

thin film of the lubricant onto each of the Chrome

 

 

 

Tubes (21). Slide an Upper Body Arm (7) onto each

 

 

 

 

Chrome Tube. Make sure that the Upper Body Arms

 

 

 

 

are turned as shown.

 

 

85

21

 

 

 

 

 

 

 

Tap a 5/8Ó Axle Cap (85) onto one end of the Axle

 

 

 

Lube

(19). Insert the Axle through one of the Upper Body

 

 

 

 

 

 

 

Arms (7) and then through the Upright (2). Slide the

 

 

19

4

other Upper Body Arm (7) onto the Axle. Tap another

 

 

 

 

 

 

5/8Ó Axle Cap (85) onto the Axle.

85

 

7

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

7

 

 

13.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.

9

Page 9
Image 9
Image IMEL08900 manual