2.Orient the Left Upright (31) as shown, and attach it to the Base (48) with two Upright Bolts (40) and two Upright Star Washers (39); do not tighten the Upright Bolts yet.
3.Attach a Wheel (45) to each side of the Base (48) with a Wheel Bolt (40), two Wheel Spacers (44), and a Nut (47) as shown. Do not over- tighten the Wheel Bolts; the Wheels should turn freely.
4.Turn the Base (48) over, and set it near the front of the treadmill as shown.
Cut the tie holding the Upright Wire (28) in a bun- dle.
Wrap the wire tie in the Right Upright (36) around the end of the Upright Wire (28). Then, pull the other end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright. Secure the Upright Wire to the top of the Right Upright so that it will not fall inside.
Raise the Uprights (31, 36) so the Base (48) is flat on the floor. Make sure that the end of the
Upright Wire (28) does not fall into the Right Upright.
2 |
|
|
|
| Latch |
|
|
| Holes |
|
|
| 48 |
|
|
| 31 |
|
|
|
|
| 39 |
|
| 39 | 40 |
|
|
| |
3 | 45 | 44 | |
| 44 |
| 40 |
|
|
| |
| 47 |
|
|
45 | 44 |
|
|
44 | 47 |
|
|
|
|
| |
40 | 48 |
|
|
4 |
|
|
|
| Large |
|
|
| Hole |
|
|
| 48 |
|
|
31 |
| Wire |
|
| Tie |
| |
| 28 |
|
|
| 36 |
| 28 |
|
|
| |
28 |
|
| |
Wire Tie
7
