| 7 |
STEP 4 (See Diagram 4) | |
A.) | Attach the Backrest Pad (#12) to the Upper Vertical Frame (#1). Secure it with two M8 x 2 ¾” |
| Allen Bolts (#28) and ∅ 5/8” Washers (#36). |
B.) | Attach the Arm Pads (#11) to the Left & Right Dip Supports (#7 & #8). Secure each Arm Pad |
| with two M8 x 2 ¾” Allen Bolts (#28) and Ø 5/8” Curved Washers (#39). |
C.) | Insert a Foam Tube (#10) halfway through the holes on the Lower Vertical Frame (#2). Push |
| two Foam Rolls (#24) onto the Tube from both ends. Plug two Foam Roll End Caps (#22) to the |
| end of the tube. |
D.) | Firmly thread each end of the Cable (#23) into the Upper and Lower Vertical Frames. |
E.) | Securely tighten all nuts and bolts pervious installed. |