Indesit IDE 44 manual Loading the Dishwasher

Loading the Dishwasher

Before placing the dishes in the racks, remove the largest scraps of food left over on your plates, you will thus avoid blocking the filter, which would reduce the efficacy of the wash.

If the saucepans and frying pans are very dirty, allow them to soak before being washed.

You will thus avoid having to wash them again.

To make it easier to load your dishes, pull the racks out fully.

How to use the lower rack

We recommend you place the most difficult dishes to wash into the lower rack: saucepans, lids, soup dishes and plates (load examples are shown in the photo).

The lower rack has tip-up sectors (see figure B), so you can place even more saucepans and frying pans or make room for the larger one

F i g . B

1

2

•Serving dishes and large lids: place them on the sides of the rack.

•Saucepans, salad bowls: must always be placed upside down.

•Very deep dishes: place them obliquely, thus allowing water to run down them and cleaning them better.

The cutlery basket (Fig. A)

This basket is equipped with a grids: insert the cutlery one by one into the slots; knives and utensils with sharp blades or tips should be positioned with the sharp parts at the bottom.

Position all cutlery items so that they don't touch. Especially long utensils should be placed in the horizontal position at the front of the upper rack.

How to Use the Upper Rack

The upper rack is designed to hold more delicate and lighter dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty).

After loading the dishes, remember to check that the blades on the sprayer arms can turn freely without knocking against any dishes.

How to adjust the upper rack ….

The upper rack can be set in a high or low position. There are two handles on the sides of the upper rack: use these to adjust its height (see figure C).

Load examples
upper rack	lower rack

fig. A

fig. C

5 EN