Indesit IDE 750 manual Troubleshooting, Malfunction Possible causes / Solutions

Troubleshooting

195060375.00

10/2006- Xerox Business Services

Whenever the appliance fails to work, check for a solution from the following list before calling for Technical

EN	Assistance Centre.
	Some problems are indicated by specific codes that flash on the display: make a note of any codes displayed
	before calling Assistance.

Malfunction:	Possible causes / Solutions:
The dishwasher does not start.	•	The plug has not been inserted into the electrical socket
		properly, or there is no power in the house.
	•	The dishwasher door has not been shut properly.
	• A delayed start has been programmed (see Start-up and use).
No water enters the dishwasher.	•	There is no water in the mains supply.
	•	The water inlet hose is bent (see Installation).
No water drains out from the	•	The dishwasher cycle has not yet finished.
dishwasher.	•	The water outlet hose is bent (see Installation).
	•	The drain duct is blocked.
	•	The filter is clogged up with food residues.
The dishwasher makes	•	The dishes are rattling against each other or against the
excessive noise.		sprayer arms.
The dishes and glasses are	•	The level of the refined salt is low or the dosage setting is not
covered in a white film or		suited to the hardness of the water (see Rinse aid and salt).
limescale deposits.	•	The lid on the salt dispenser is not closed properly.
	•	The rinse aid has been used up or the dosage is too low.
	•	The crockery is made from non-stick material.
The dishes and glasses are
streaked or have a bluish	•	The rinse aid dosage is too high.
tinge.
The crockery has not been dried	•	The rinse aid has been used up or the dosage is too low (see
properly.		Rinse aid and salt).
	•	The rinse aid dispenser setting is not high enough.
	•	A wash cycle without a drying programme has been selected.
The dishes are not clean.	•	The racks are overloaded (see Loading the racks).
	•	The crockery has not been arranged well.
	•	The sprayer arms cannot move freely.
	•	The wash cycle is too gentle (see Wash cycles).
	•	The detergent has not been measured out correctly or it is not
		suited to the type of wash cycle (see Start-up and use).
	•	The filter is dirty or blocked (see Care and maintenance).
	•	The refined salt level is low (see Rinse aid and salt).
Shut off tap alarm.	•	Turn on the tap and the appliance will start after a few
(you will hear several short beeps)		minutes.
(the code AO6 flashes on the	•	The appliance lock has been activated because nothing was
display).		done when the beeps sounded. Switch off the machine using
		the ON/OFF button, turn on the tap and switch the machine
		back on after 20 seconds by pressing the same button. Re-
		programme the machine and restart the wash cycle.
Blocked filter alarm	•	Switch off the machine by pressing the ON/OFF button and
(the code AO5 flashes on the		clean the filters (see Maintenance), then switch the
display).		dishwasher back on by pressing the same button. Re-
		programme the machine and restart the wash cycle.
Water loading solenoid valve	•	Switch off the appliance by pressing the ON/OFF button and
malfunction alarm		switch it back on after a minute. If the alarm continues, turn
(the code AO2 flashes on the		off the water tap to reduce the risk of flooding, remove the
display).		plug from the electrical socket and call Assistance.

12