Indesit IDS 105 manual Electrical Connection

Models: IDS 105

1 16
Download 16 pages 19.91 Kb
Page 4
Image 4
Electrical Connection

Electrical Connection

Electrical Connection

EN

If your appliance is supplied with a 13 amp. fused plug

 

 

it can be plugged into a 13 amp socket for immediate

 

use. Before using the appliance please read the

 

instruction below.

 

 

WARNING: THIS APPLIANCE MUST BE

 

 

 

EARTHED.

 

THE FOLLOWING OPERATIONS SHOULD BE

 

CARRIED OUT BY A QUALIFIED ELECTRICIAN.

 

Replacing the fuse:

 

When replacing a faulty fuse, a 13 amp ASTA

 

approved fuse to BS 1362 should always be used, and

 

the fuse cover re-fitted. If the fuse cover is lost, the

 

plug must not be used until a replacement is obtained.

As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminal in your plug, proceed as follows:

connect Green & Yellow wire to terminal market “E” or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red.

Connect Blue wire to terminal marked “N” or coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board.

If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

Replacemente fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colours as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with the following code:

Removing the plug:

Ifyour appliance has a non-rewireable moulded plug and you should wish to remove it to re-route the mains cable through partitions, units etc., please esure that either:

- the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval

-or:

-the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS

5733) which is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket.

BLUE

“NEUTRAL” (“N”)

BROWN

“LIVE” (“L”)

GREEN AND YELLOW

“EARTH” (“E”) or

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Instruction for connecting cable to an altenative plug:

Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow

- Earth

Blue

- Neutral

Brown

- Live

Manual background CAUTION:

-Once the appliance has been installed, the electrical plug and socket should remain accessible.

-The Company shall not be held responsible for any incidents that occur if these regulations are not observed.

Disposing of the appliance:

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

4

Page 4
Image 4
Indesit IDS 105 manual Electrical Connection