Indesit IDTM manual Technical data, Electrical connection

Connecting the water outlet hose

Connect the outlet hose (without bending it) to a drain duct with a minimum diameter of 4 cm. Alternatively, rest it over a sink or tub; the free end of the hose should not remain immersed in water.

AThe special plastic

elbow* makes it easier to

find the best layout: fix

the elbow to the wall

securely in order to

prevent the outlet hose

from moving and spilling

the dirty water.

The part of the hose marked with the letter A

should be between 40 and 100 cm above the ground (see figure).

￿We advise against the use of hose extensions.

Electrical connection

Before inserting the plug into the electrical socket, make sure that:

•the socket is earthed and complies with current regulations;

•the socket can withstand the maximum load of the appliance, which is indicated on the data plate located on the inside of the door (see Description of the appliance);

•the power supply voltage falls within the values indicated on the data plate on the inside of the door;

•the socket is compatible with the plug of the appliance. If this is not the case, ask an authorised technician to replace the plug (see Assistance); do not use extension cables or multiple sockets.

￿Once the appliance has been installed, the power supply cable and the electrical socket should be easily accessible.

￿The cable should not be bent or compressed.

￿The cable should be checked regularly and

EN

replaced by authorised technicians only.

￿The Company shall not be held responsible for any incidents that occur if these regulations are not observed.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before running the first wash cycle, completely fill the salt dispenser with water and add approximately 2 kg of salt (see Rinse aid and refined salt). The water may overflow: this is normal and is not a cause for concern. It is also normal that the LOW SALT* indicator light continues to flash for a few cycles after the salt has been loaded.

Technical data

	width 60 cm
Dimensions	height 85 cm
	depth 60 cm
Capacity	12 standard place-settings
Water supply	30 KPa ÷ 1 MPa
	(0,3 ÷ 10 bar)
pressure
	4,3 psi-145 psi
Power supply	See appliance data plate
voltage
Total	See appliance data plate
absorbed
power
Fuse	See appliance data plate
	This dishwasher conforms to
	the following European
	Community Directives:
	-73/23/EEC dated 19/02/73
	(Low Voltage) and subsequent
	modifications
	-89/336/EEC dated 03/05/89
	(Electromagnetic Compatibility)
	and subsequent modifications)
	-97/17/EC (Labelling)
	- 2002/96/EC(WEEE)

* Only available in selected models.

3