Electrical connections
Before plugging the appliance into the socket, check the following:
• | Make sure your hands are dry. |
• | The socket must have an earth connection. |
Levelling the tumble dryer
The tumble dryer should be installed level in order to operate correctly.
EN
• | The socket must be able to withstand the machine’s ma- |
ximum power output as indicated on the Rating plate (see | |
Description of the tumble dryer). | |
• The power supply voltage must fall within the values indicated | |
on the Rating plate (see Description of the tumble dryer). | |
• | The socket must be compatible with the dryer’s plug. |
Should this not be the case, replace the plug or the socket. | |
! | Do not use extension cords. |
! | The dryer must not be installed outdoors, even if the space |
is sheltered. It can be very dangerous if exposed to rain or | |
storms. | |
! | Once installed, the dryer’s electrical wire and plug must be |
within reach. | |
! | The power cord must not be bent or squashed. |
! | The power cord is supplied fitted with a BS1363 plug |
and with a 13 amp BS1362 fuse. If it is necessary to fit a | |
replacement fuse, it must be a 13 Amp ASTA approved | |
to BS1362 type. WARNING: The plug must not be used | |
without a fuse cover. If a replacement fuse holder/cover is | |
required, it must be of the same colour coding or wording as | |
shown on the base of the plug. | |
Replacements are available from authorised dealers. |
Moulded plug
Changing the plug
The wires in the power cord are coloured in accordance with the following.
Green and Yellow (Earth) |
|
| 13A ASTA approved fuse |
wire to terminal marked “E”, |
|
| to BS 1362. |
symbol x, or coloured green | GREEN & |
|
|
and yellow. | YELLOW |
|
|
| BROWN | 13 ampere fuse |
|
|
|
| |
Blue (Neutral) wire to |
|
| Brown (live) wire to |
BLUE | teminal marked “L” or | ||
terminal marked ”N” or |
| CORD GRIP | coloured red. |
coloured black. |
|
|
|
|
|
|
|
!If the plug being replaced is a
!The power cord should be checked periodically and replaced by a cord specially prepared for this dryer and fitted only by authorized technicians (see Service). New or longer power cords are supplied at an extra charge by authorized dealers.
!The manufacturer denies any responsibility should any of these rules not be followed.
!If in doubt about any of the above consult a qualified electrician.
After installing the tumble dryer in its permanent position, make sure it is level; check its
If the tumble dryer is not perfectly level, use a wooden block to support it while you adjust the two front feet, up or down as necessary.
Before you start your dryer
Once the tumble dryer is installed, clean the inside of the drum before operating it and remove any dirt accumulated during transportation.
3