Maintenance and care
GB
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply:
1.set the FREEZER OPERATION and APPLIANCE ON/OFF Knob on Off
2.pull the plug out of the socket
!If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. To restore normal operation, it is sufficient to set the FREEZER OPERATION and APPLIANCE ON/OFF knob on the desired value. To disconnect the appliance, follow point 1 and 2.
Cleaning the appliance
•The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia.
•The removable accessories may be soaked in warm water and soap or dishwashing liquid. Rinse and dry them carefully.
Avoiding mould and unpleasant odours
•The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly.
•If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open.
Defrosting the appliance
!Follow the instructions below.
Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair.
Defrosting the freezer compartment
If the frost layer is greater than 5 mm, it is necessary to defrost manually:
1.One day before enabling the SUPER FREEZE function in the
2.Turn the appliance off by turning the FREEZER OPERATION and APPLIANCE ON/OFF knob.
! this operation switches off the whole appliance (including the fridge compartment).
3.Wrap frozen foods in newspaper and place them in another freezer or in a cool place.
4.Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment.
5. Certain appliances are fitted with the DRAIN SYSTEM to lead the water outside: insert the scraper into the slot provided at the bottom and let the water flow into a container (see diagram).
6.Clean and dry the freezer compartment carefully before switching the appliance on again.
! Remember that the motor will not start immediately, but rather after approximately 8 minutes.
7.Wait for approximately 2 hours, i.e. until the ideal storage conditions have been restored, before placing food in the freezer compartment.
Defrosting the refrigerator compartment
The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a
Replacing the light bulb
To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Follow the instructions below.
special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily.
A |
B |
Access the light bulb (A) by unscrewing the fixing screw (B) which is located at the back of the lampcover, as shown (see diagram). Replace it with a similar light bulb, the power of which should not exceed 15W.
8
