Installation
The following instructions should be read by a qualified technician to ensure that the appliance is installed, regulated and technically serviced correctly in compliance with current regulations.
Important: disconnect the cooker from the electricity when making any adjustement, maintenance operation, etc.
Positioning
The appliance can be installed next to furniture units which are no taller than the top of the cooker hob.For proper installation of the cooker, the following precautions must be taken:
a)Kitchen cabinets installed next to the cooker that are taller than the top of the hob must be situated at least 200 mm from the edge of the hob.
b)Hoods must be installed according to the requirements in the installation manual for the hoods themselves and in any case at a minimum distance of 650 mm.
c)Place the wall cabinets adjacent to the hood at a minimum height of 420 mm from the hob (see figure).
d)Should the cooker be installed beneath a wall cabinet, the latter should be situated at least 700 mm (millimetres) away from the hob, as shown in the figure.
e)the
HOOD
| Min. 600 mm. | min. 650 mm. with hood min. 700 mm. without hood |
Min. 420 mm. | Min. 420 mm. |
Levelling your appliance (only on a few models)
Your cooker is supplied with feet for levelling the appliance. If necessary, these feet can be screwed into the housings in the corners of the cooker base (Fig. A).
Mounting the legs (only on a few models)
N.B.: the following installation procedure must be carried out by a qualified electrician.The electrical installation must comply with the IEE Regulations, Building & local
For the installation of the feeding cable carry out the following operations:
lUnscrew screw “V” (see fig. A)
lPull and open the junction blok lid
Important: the wires in the mains lead are coloured in accordance with the following code:
Green &Yellow | Earth |
Blue | Neutral |
Brown | Live |
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
Green & Yellow wire to terminal marked “E” or 6 or coloured Green or Green &Yellow.
Brown wire to terminal marked “L” or coloured Red.
Blue wire to terminal marked “N” or coloured Black (see fig. B).
lfix the feeding cable in the special cable stop and close the cover.
N.B.: the power supply cable must have these minimum requirements:
Type:
Section: 3x4 mm2
V |
Fig. A | Fig. B |
Connecting the supply cable to the mains
WARNINGS:THIS APPLIANCE MUST BE EARTHED.
Important: The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the consumer unit to the cooker, via the switched double pole cooker outlet, must be of an acceptable type and current rating as above.
Note: thesupplycablemustbepositionedsothatitneverreaches at any point a temperature 50°C higher than the room tempera- ture.The cable must be routed away from the rear vents.
Fig. A | Fig. B |
Electrical connection
Electric cookers come without a power supply cable.The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate.The cooker can be connected to the mains only after removing the back panel of the cooker itself with a screwdriver.
HOT PARTS
4
