HOT PARTS

Important: make sure the supply pressure conforms with the values shown in the table entitled “Caracteristics of the burners and nozzles”. When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

•the hose must never be at any point in its lenght in contact with the “hot” parts of the cooker;

•the hose must never be longer than 1,5 metre;

•the hose must not be subject to any tension or torsional stress and it must not have any excessively narrow curves or bottlenecks;

•the hose must be easy to inspect along its entire length to check its condition;

•the hose must always be in good condition, never attempt to repair.

Important: the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the above, by low, a qualified, corgi approved engineer must be called for installation.

Electrial connection

Power supply voltage and frequency:230-240V a.c.50/60 Hz.

Note: the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature.The cable must be routed away from the rear vents. Should you require it, you may use a longer cable, however, you must ensure that the cable supplied with the appliance is replaced by one of the same specifications in accordance with current standards and legislation.

Your appliance is supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re- fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained.

Removing the plug:

If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a cable extension or to re-route the mains cable through partitions, units etc., please ensure that either:

•the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval.

or:

•the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Please note: for appliances with a rating greater than 13

amp (eg: electric hob, double ovens and freestanding electric cookers etc.) the mains cable must be wired into a cooker output point with a rating of 45 amp. In this case the cable is not supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow

- Earth

Blue

- Neutral

Brown

- Live

If the colours of the wires in the mains lead do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked “E” or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red. Connect Blue wire to terminal marked “N” or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with

the following code:

 

 

BLUE

“NEUTRAL” (“ N”)

BROWN

“LIVE” (“L”)

GREEN AND YELLOW

“EARTH” (“E”)

 

 

 

 

 

GREEN &

 

 

 

YELLOW

 

 

 

BROWN

13 amp fuse

 

 

 

 

 

BLUE

CROSS-BAR

 

 

 

CORD GRIP

 

 

 

 

 

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

5

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

Page 4 Page 6
Page 5
Image 5
Indesit K3G11/G Connecting the gas supply, Electrial connection, Replacing the fuse, Removing the plug, Following code
Page 4 Page 6

K3G11/G specifications

The Indesit K3G11/G is a versatile and efficient gas cooker designed to meet the needs of modern households. This appliance combines functionality with practicality, making it a popular choice among cooking enthusiasts and beginners alike. With a range of features and technologies, it stands out as a reliable partner in the kitchen.

One of the most notable aspects of the Indesit K3G11/G is its four gas burners, which come in different sizes to accommodate various cooking needs. These burners allow for precise control over cooking temperatures, enabling users to simmer, boil, or fry with ease. The front-facing controls ensure that adjusting the heat is straightforward, providing convenience when multitasking in the kitchen.

A key feature of the Indesit K3G11/G is its integrated grill, perfect for preparing a variety of meals such as grilled meats, vegetables, and toasts. This grill enhances cooking versatility, allowing users to achieve an appealing texture and flavor in their dishes. The appliance also includes a spacious oven, which offers ample capacity for baking, roasting, and other cooking methods.

The oven is equipped with a conventional heating system, providing even heat distribution for consistent cooking results. The enamel interior of the oven makes cleaning more manageable, as it resists food residues and stains. Moreover, the double-glazed oven door ensures safety and energy efficiency while retaining heat during cooking.

Safety is a priority in the design of the Indesit K3G11/G. It features a flame failure device, which automatically cuts off the gas supply if the flame goes out, reducing the risk of gas leakage. Additionally, the appliance has sturdy legs that ensure stability, even when cooking with heavy pots and pans.

In terms of design, the Indesit K3G11/G boasts a sleek, modern appearance with a stainless steel finish, making it an attractive addition to any kitchen decor. Its compact size is ideal for smaller spaces, while still providing ample cooking capabilities.

In summary, the Indesit K3G11/G gas cooker is a reliable and efficient appliance that combines essential cooking features with user-friendly design. With its gas burners, grilling capabilities, spacious oven, and safety features, it offers a practical solution for everyday cooking needs, ensuring delicious meals can be prepared with ease.
Top Page Image Contents