Installation Instructions
LEVELLING
Two rear wheels and two front feet are fitted which can be adjusted up or down to set the height (915mm) and level the cooker.
1.The rear wheels can be raised or lowered from the BACK of the cooker by adjusting the levelling screws ‘A’ in the plinth.
2.The front feet can be simply screwed in or out to lower or raise the front of the cooker.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.
NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves
VIEWED FROM REAR
STABILITY BRACKET
The back of the cooker has a slot for engagement of a stability bracket, which can be obtained, as an extra, from your cooker supplier.
CONNECTING TO GAS SUPPLY
The cooker is designed to match the depth of standard 600mm worktops. An adaptor backplate should, therefore, be fitted within the shaded area shown to allow the cooker to be pushed fully to the wall.
| 220mm |
|
|
|
|
|
|
| REAR OF | ||
|
|
|
| COOKER | |
GAS | 70mm |
|
|
|
|
BACKPLATE |
|
|
|
| |
|
|
|
|
| |
POSITION |
|
|
|
|
|
|
| 125mm | |||
STABILITY | 450 mm |
|
|
|
|
635mm |
|
|
|
| |
BRACKET |
|
|
|
| |
|
|
|
|
| |
POSITION |
|
|
|
|
|
|
|
|
|
|
|
|
| SLOT FOR | |||
|
|
| STABILITY |
| |
|
|
| BRACKET |
| |
|
|
|
|
|
|
Connection to the cooker should be made with an approved appliance flexible connection to BS 669. Hoses connected to LPG should be suitable for LPG and capable of withstanding 50mbar pressure A length of 0.9 to 1.25m is
recommended. The length of hose chosen should be such that when the cooker is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are likely to come in contact
with the flexible hose do not exceed 70˚C.
27
