Indesit CA 55 XX Troubleshooting, Malfunctions, Possible causes / Solutions, beginning to freeze

Models: CAA 55 XX CA 55 XX NCAA 55 XX

1 12
Download 12 pages 41.63 Kb
Page 10
Image 10
Troubleshooting

Troubleshooting

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.

GB

Malfunctions:

Possible causes / Solutions:

The internal light does not illuminate.

The refrigerator and the freezer do not cool well.

The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house.

The doors do not close properly or the seals are damaged.

The doors are opened too frequently.

The TEMPERATURE ADJUSTMENT knob is not in the correct position

The refrigerator or the freezer have been over-filled.

The atmospheric temperature of the area surrounding the appliance is lower than 14°C.

The food inside the refrigerator is

The TEMPERATURE ADJUSTMENT knob is not in the correct position.

beginning to freeze.

The food is in contact with the back inside wall of the refrigerator.

The motor runs continuously. • The door is not closed properly or is continuously opened.

The outside ambient temperature is very high.

The thickness of the frost exceeds 2-3 mm (see Maintenance).

The appliance makes a lot of noise.

The appliance has not been installed on a level surface (see Installation).

The appliance has been installed between cabinets that vibrate and make noise.

The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal.

Some of the external parts of the refrigerator become hot.

The back wall of the refrigerator unit is covered in frost or droplets of water.

These raised temperatures are necessary in order to avoid the formation of condensation on certain parts of the product.

This shows the appliance is operating normally.

There is water at the bottom of the

• The water discharge hole is blocked (see Maintenance).

refrigerator.

 

Icing water at rear of the Fridge

• Make sure that the “Fast Freeze switch” (see pag 7 for details) is NOT

 

in the ‘ON’ position, this will cause 100% run. If switch is not in ON

 

position and severe icing persists, set temperature regulating knob

 

(see pag 5 for details) to lower position.

Excess moisture / Ice at rear of the Fridge

Warm Fridge

Excess moisture / Ice will occur if the Larder door is opened for prolonged periods. This will disappear once the door is closed and the Larder allowed to defrost and drain the moisture away. This is normal for cooling function of the Larder compartment, especially in summer period.

If room temperature is 7 C or lower, (for example the product is located in a garage or out building), for the refrigerator to operate correctly the “Fast Freeze switch” must be in the ‘ON’ position (see pag 16 for details)

10

Page 10
Image 10
Indesit CA 55 XX Troubleshooting, Malfunctions, Possible causes / Solutions, The internal light does not illuminate