14
GB The machine leaks.
The 'DOOR LOCKED' indicator
light flashes rapidly.
The machine smells.
The machine door cannot be
opened.
Door Seal damaged at the
bottom
There is too much foam.
After completing the
programme, or before starting
a programme, the machine has
turned itself off (no lights).
General.
The fill hose is loose, check both the cabinet and tap ends.
The fill hose is tight but still leaks, if so replace the rubber washers, or
the fill hose is missing the rubber washer.
The drain hose is not fixed in properly.
Switch off the machine and unplug it, wait for approximately 1 minute
and then switch it back on again If the problem persists contact the
Technical Assistance Service.
The machine requires a service wash. Run a 60 degree wash cycle with
detergent and no laundry.
The door will not open until the door lock indicator light goes out
shortly after the program has finished.
The door seal has drainage holes at the bottom - This is normal.
The detergent is not suitable for machine washing (it should display the
text 'for washing machines' or 'hand and machine wash' or the like).
Too much detergent was used - less detergent is required in soft water.
To comply with new energy saving regulations the machine is fitted
with an automatic standby system. Press 'ON/OFF' button for 3
seconds to activate the machine, it can then either be switched off or
a new programme selected.
Your washing machine contains sensors that monitor progress during
the wash cycle (eg: Water Levels, Temperatures, Out of Balance
loads, Wash time/progress). Normally, if your machine successfully
completes the cycle, there is unlikely to be anything wrong!
Remember, you will be charged for a service call for problems caused by incorrect installation,
as listed above.
Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine.
Do not wash items which do not have a wash label, or wash items that are not intended as
machine washable.