Indesit TAN 6 FNF S manual Troubleshooting, Malfunctions, Possible causes / Solutions, Description

Troubleshooting

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.

GB

Malfunctions: Possible causes / Solutions:

The green POWER indicator light does not illuminate.

The motor does not start.

The indicator lights are on but the light is dim.

a)The alarm sounds.

b)The alarm sounds and the two yellow indicator lights flash.

c)The alarm sounds and the two yellow indicator lights as well as the green one flash.

Heating

is excessive

+ buzzer

Heating danger

+ buzzer

•The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house.

•The appliance comes with a motor protection control (see Start-up and use).

•Pull out and reverse the plug before putting it back in the socket.

a)The refrigerator door has remained open for more than two minutes (the buzzer will stop sounding when you shut the door) or the correct switching-off procedure was not followed (see Maintenance).

b)The temperature in the freezer is too high. Check the quality of the food products and dispose if necessary.

c)The temperature in the freezer has reached a dangerous level. The food must be disposed immediately.

b/c) In the first case the freezer will maintain a temperature of about 0°C so that the food does not re-freeze. In the second case, however, the temperature will remain at approximately 0°C.

To turn off the acoustic signal open and close the refrigerator door. To restore normal operation bring the FREEZER OPERATION knob setting to (off) and turn the appliance on again.

The green POWER indicator light flashes.

The refrigerator and the freezer do not cool well.

•The appliance is not operating correctly. Contact the Technical Assistance Centre.

•The doors do not close properly or the seals are damaged.

•The doors are opened too frequently.

•The OPERATION knobs are not on the correct setting (see Description).

•The refrigerator or the freezer have been over-filled.

The food inside the refrigerator is	•	The REFRIGERATOR OPERATION knob is not on the correct setting (see
beginning to freeze.		Description).
	•	The food is in contact with the back inside wall of the refrigerator.

The motor runs continuously. • The SUPER FREEZE button has been pressed (rapid freezing): the yellow SUPER FREEZE light is on (see Description).

•The door is not closed properly or is continuously opened.

•The outside ambient temperature is very high.

The appliance makes a lot of noise.

Some of the external parts of the refrigerator become hot

•The appliance has not been installed on a level surface (see Installation).

•The appliance has been installed between cabinets that vibrate and make noise.

•The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal.

•Temperaturile ridicate sunt necesare pentru a evita formarea apei de condens în anumite zone ale produsului.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24

10