Infinity Automotive Loudspeaker Components manual Flush-Mount, Surface-Mount, TWEETER ANGLE Figure

INSTALLATION

FLUSH-MOUNT

Figure 5A. Mounting the tweeter using the I-Mount™ (patent no. 5,859,917) flush-mounting kit.

3

1 2

Note: Aim the tweeter at the listening position by sliding the stud in the groove on the back of the tweeter cup and rotating the entire assembly in the mounting surface. Lock the tweeter in place, using the small retaining screw.

SURFACE-MOUNT

Figure 5B. Mounting the tweeter using the I-Mount surface-mounting kit.

TWEETER ANGLE

Figure 6.

3

ROTATE ENTIRE ASSEMBLY

TO AIM ANGLED TWEETER

TOWARD LISTENER.

1

SLIDE SCREW UP OR

DOWN TO ADJUST

TWEETER ANGLE.

2

TIGHTEN SCREW TO

LOCK ANGLE SETTINGS.

4

SECURELY TIGHTEN

THE LARGE HAND NUT.

Figures 7A through 7D. The Starfish™ tweeter mount is intended to be used when the tweeter

Figure 7A. Behind grille panel. Figure 7C. Mounted to grille panel.

Figure 7B. Mounted to surface behind	Figure 7D. In-dash location (may require gluing).
grille panel.

1

ATTACH BASE

WITH SCREWS,THEN:

2

3

BLACK (—)

RED (+)

will be installed behind a factory grille (e.g., replacing the factory tweeter behind a door panel). The Starfish will allow you to mount the component tweeter directly to the panel itself or to the area behind the panel.The six mounting tabs can be removed easily to create a number of custom configurations.The tabs of the Starfish can be screwed or glued to the mounting surface for secure installation.

Note: Check screw clearance before installing.

Use glue if clearance is an issue.

Note: Not all possible mounting configurations

referenceare shown.series