Infinity manual WALL-MOUNTING the C205, Installing Spiked Feet, WALL-MOUNTING the CC225, C336

WALL-MOUNTING THE C205

The C205 is designed to be mounted directly to a wall. Each speaker has two keyholes on the back, and will require (2) 1-1/2," #8 wood screws with a .33" (8.4mm) screwhead fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2," #8 screw.

NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.

Keyhole mounts

Attach rubber bumper

Figure 4.

Step 1.

Mark the positions on the wall where you would like to place the mounting screws.

Step 2.

Fasten two 1-1/2," #8 wood screws to the wall using the markings placed in Step 1 as your guide. Leave an 11/16" space between the wall and screwhead. If a wall stud is not available, use an appropriate anchor.

Step 3.

Place the speaker on the wall by aligning the keyholes on the back of the speaker to the screwheads on the wall. Once positioned properly, the speaker should slide down slightly and become secure.

INSTALLING SPIKED FEET

C336

Four metal spikes are supplied for use when using the outboard feet and the speaker is to be placed on a carpeted surface to decouple the speaker from the floor and prevent unwanted damping. To insert the spikes, gently lay the speaker on its back (not its front or side) on a soft, nonabrasive surface, unscrew the four rubber-tipped feet and store in a safe place. Each spike then screws into the threaded insert. Make sure all four spikes are screwed in completely for stability.

NEVER drag the speaker to move it, as this will damage the spikes, the feet, the wood cabinet itself, and/or the floor. Always lift the speaker and carry it to its new location.

WALL-MOUNTING THE CC225

The CC225 is designed to be mounted directly to a wall. The bracket has four holes on the back, and will require (4) 1-1/2," #8 wood screws with a .33" (8.4mm) screwhead fastened to wall studs. If wall studs are unavail- able, install anchors appropriate for a 1-1/2," #8 screw.

NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.

Step 1.

Attach the wall bracket to the wall at the desired location.

Step 2.

Securely fasten the two cleats to the rear of the speaker, using two included 1/4"-20 panhead screws per cleat.

Step 3.

Carefully slide the cleats on the rear of the speakers over the tabs of the wall bracket.

Top view

INFINITY CLASSIA 3