WALL-MOUNTING
The Infinity Beta ES250 speaker is designed to mount directly to a wall. Each speaker has (4) keyholes in the rear to allow either left- or
(2)
the diagrams for more assistance.
NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe
Step 1.
Position the supplied
(349mm)
Wire Channel
Figure 11.
Step 2.
Fasten (2)
Step 3.
Attach speaker wire, as shown on page 4.
Step 4.
Place the speaker on the wall by aligning the upper two keyholes on the back of the speaker to the screwheads on the wall. Once positioned properly, the speaker should slide down slightly and become secure.
IMPORTANT NOTE: The set of drivers closer to the monopole setting indicator in Figure 3 should be installed toward the front of the room. It does not matter whether or not the tweeter is positioned above or below the woofer. This will ensure proper operation and performance should the Monopole or Dipole position on the surround mode configuration switch be selected.
BETA ES250 | 5 |