Figure 3. After the Kappa10.1t tweeter is in its cup, hand tighten the nut to
NOTE: You must use the crossover supplied with the 10.1t tweeter. The crossover is con- tained in the shrink tube attached to the included speaker wire. If you must shorten the wire, do not remove the crossover, and be sure that its orientation is correct (indi- cated by position of connectors).
A NOTE ON POWER HANDLING
The Kappa 10.1t tweeters are designed to produce reasonable volume levels with little amplifier power. However, the addition of an amplifier to drive your speakers and a subwoofer will enhance the dynamic range of your system, and help overcome the ambient noise in a moving vehicle. Kappa speakers are designed to handle the power of a dedicated amplifier driven at or below its rated power. If an amplifier is driven far above its rated power, the output signal will “clip,” and the additional power present in a clipped signal can damage any speaker. Distorted or “fuzzy” sound from your speakers is an indication that the amplifier has exceeded its rated power, and you should reduce the volume level.
GENERAL CARE |
| SPECIFICATIONS |
|
The loudspeaker grilles may be cleaned with a |
|
|
|
slightly damp cloth. Do not use any cleaners or |
| 10.1t |
|
solvents on the grilles or the speaker drivers. |
| Type: | ComponentTweeter |
|
| Speaker Impedance: | 4 ohms |
|
| Power Handling: | 50 watts per channel |
|
|
| with crossover |
|
| Frequency |
|
|
| Response (± 3dB): | 8kHz ~ 22kHz |
|
| Sensitivity: | 89Hz @ 2.83 V, 1 watt |
|
| Crossover Frequency: | 8000Hz |
|
|
DECLARATION OF CONFORMITY
We, Infinity Systems A/S
Kongevejen 194B
DENMARK
declare in own responsibility, that the product described in this owner’s manual is in compliance with technical standards: EN 50
Infinity Systems, Inc. • 250 Crossways Park Drive,
®Woodbury, NY 11797 USA • (516)
EN 50
- 3 -