SUBWOOFER CONNECTIONS
CHOOSE THE SUBWOOFER CONNECTION THAT IS MOST SUITABLE FOR YOUR RECEIVER/PROCESSOR
If you have a Dolby* Digital or DTS® receiver/processor with a
If your receiver/processor does not contain a Dolby Digital or DTS processor but has a subwoofer output:
RECEIVER/PROCESSOR
SUBWOOFER OR
LFE OUTPUT
L R
OUT IN
++
If your receiver/processor does not have subwoofer outputs for the left and right channels or an LFE output, connect speaker wire from your receiver/amplifier to your speakers and subwoofer using two sets of speaker wire:
RECEIVER/AMPLIFIER
Front Speaker Output
HIGH LEVEL INPUT | |
| + |
| – |
L | R |
OUT IN
++
NOTE: Some receivers have one subwoofer output.
In that case, it is recommended that you use a Y connector (not included) to maximize performance.
RED = +
BLACK = –
1.LOOSEN TERMINALS
2.INSERT BARE END; TIGHTEN TERMINALS
NO STRIPE = – |
| STRIPE = + |
|
|
|
|
|
|
This figure shows how to connect bare wires to the terminals.
