Wall-Mounting the Transmitter Module
NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe
Step 1.
Insert the two M3 x 4 machine screws through the wall bracket and into the rear of the transmitter module, as shown in the figure below.
Step 2.
Attach the transmitter module with wall bracket to the wall, using suitable hardware and, if necessary, wall anchors.
ROOM ADAPTIVE BASS OPTIMIZATION SYSTEM™
The Infinity R.A.B.O.S.™ technology is a
By following these instructions, you will optimize the subwoofer’s response characteristics to complement the sub’s environment. This will dramatically improve the sound of your system. The optimization process takes less than 30 minutes.
The Optional R.A.B.O.S. Kit Includes
the Following Components:
•Specialized
•Test CD
•Instructions
•Measurement Templates
•Width Selector
•Adjustment “Key”
What R.A.B.O.S.Technology Does
The Test CD provides specially designed signals you will use while performing measurements. The
The R.A.B.O.S. Goal
It is a fact of audio that what we hear at low frequencies is determined as much or more by the listening room than by the loudspeaker itself. Placement of the loudspeakers and listeners and the acoustical characteristics of the room surfaces are all important determinants of bass quantity and quality. In most practical situations, there is little that can be done about this, except for patient
of a living space and the impracticality of massive acoustical treatment mean that equalization is the only practical solution.
Professional sound engineers routinely employ sophisticated measurement systems and equalizers to optimize speakers to the installation. This has never been practical for the home audiophile. This is why R.A.B.O.S. technology was created. It enables you to identify the dominant
Performing R.A.B.O.S.Tests
These instructions assume you have already installed your subwoofer according to the information provided in the owner’s guide. It is also assumed that all equipment in your entertainment system is interconnected properly and is in good operating condition.
Preparations
Before beginning R.A.B.O.S. tests, please check the following:
•Set R.A.B.O.S. System Selector ⁄ to the “On” position.
•Make sure all three R.A.B.O.S. controls (¤, and ) on the subwoofer are turned fully clockwise.
•Make sure the loudness contour (if any) on your receiver/ processor/preamp is turned off.
•Set the tone controls (Bass and Treble) to their center or flat positions.
•Bypass all surround and effects features of your receiver/ processor/preamp or set to “Stereo Bypass.”
•If you are using a multichannel surround processor or receiver, make sure all
You must have a CD player in the system. A CD player remote control is quite convenient but not essential.
For best results, it is recommended that all major furnishings are in place and that all doors and windows in the listening area are in their normal positions.That is, if you normally listen to music with all doors closed, then this is how they should be during this procedure.
Try to minimize ambient noise while running tests.Turn off all major appliances and any air conditioning or furnace fans.These can create significant subsonic noise that may be barely perceptible but which can wreak havoc on
Critical information is highlighted with this mark: 
Helpful hints are marked with this symbol: 
