Infinity QPS1 owner manual Wiring the System, Testing the Speakers

WIRING AND POLARITY...

IMPORTANT!

Figure 4. QPS-1 surround speakers feature gold-plated terminals that can be connected in several different ways; e.g., banana plugs, spade terminals (not shown) and direct wiring.

WIRING THE SYSTEM

After placing the speakers, you are ready to connect your system. First turn off all audio system power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals (included with your amplifier, receiver or television) for connection and operation procedures.

QPS-1 speakers have gold-plated terminals that accept a variety of wire connectors (see Figure 4 below). Observe correct polarities when making speaker connections, as shown in Figure 5 (on page 6).

Connect each + terminal on the back of the amplifier, receiver or television to the respective

+(red) terminal on each speaker. Connect the – (black) terminals in the same way.

Do not reverse polarities (e.g., + to - or - to +) when making connections.

TESTING THE SPEAKERS

After placing and wiring the speakers, turn on audio system power. Follow the instructions (packed with your A/V preamplifier or receiver) to calibrate the Dolby® Pro Logic® or Dolby Digital channels. Most components include a built-in test tone to help you balance the sound levels to all speakers in your system. During calibration, verify that each QPS-1 reproduces the test tone. If not, check the wiring connections and see the Troubleshooting chart (on page 7) for help.

Speaker Wire		Speaker Wire
No Stripe = +	Stripe = –	Stripe = –	No Stripe = +
		❷ Insert Bare End;
Red = +		Tighten Terminal	Red = +
Black = –	❷ Insert Bare	Black = –
	Wire End;
	Tighten Cap.
❸ Insert Plug
Into Connector.		❶ Loosen Terminal.
		CONNECTING SPEAKERS
		DIRECTLY TO WIRES

❶Loosen Cap.

CONNECTING SPEAKERS

USING BANANA PLUGS (NOT SUPPLIED)

Infinity QPS-1 – Owner’s Manual ◆ 5