Tilting the Speaker
If needed, the enclosed stand allows you to tilt the speaker across a wide range (i.e., up a maximum of 18˚ or down a maximum of 7˚), as shown in Figure 3.
Important!
Do not exceed the tilt range. Doing so may cause the speaker to fall out of its stand.
Figure 3.
WIRING THE SPEAKER
After placing the speaker, you are ready to connect it to your system. First, turn off all audio system power. Use
Surround Modes
When using the
Wiring and Polarity
The
+terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown in Figure 4. Connect the – (black) terminals in a similar way. See the owner’s manuals that were included with your amplifier or receiver to confirm connection procedures.
Important!
Do not reverse polarities (i.e., + to – or – to +) when making connections. Doing so will degrade the imaging and bass response of the home theater system.
After correctly placing and wiring the
2
1
–+
Figure 4. This example shows how to connect bare wires to the terminals. Banana plugs may also be inserted directly into the rear of the connector.
1Loosen the terminals.
2 Insert bare ends; tighten terminals.
