CONNECTIONS
After placing the speakers, you are ready to connect your system. First, turn off all
Observe polarities when making speaker connections, as shown in Figure 4. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker.
Connect the – (black) terminals in the same way.
Important!
Do not reverse polarities (i.e., + to
Insert Bare |
|
End; Release | Press |
Connector | Connector |
| In and |
| Hold |
– +
Figure 4. Wiring diagram shows polarity connections for one channel of a home theater system.
MAINTENANCE AND SERVICE
The
All wiring connections should be inspected and cleaned or remade periodically.The frequency of maintenance depends on the metals involved in the connections, atmospheric conditions and other factors, but once per year is the minimum.
If a problem occurs, make sure that all connections are properly made and clean. If a problem exists in one loudspeaker, reverse the connection wires to the left and right system. If the problem remains in the same speaker, then the fault is with the
E N G L I S H