Connecting the LitePro 760
Connecting a Sun, SGI, Intergraph or NeXT Workstation
Follow this procedure if your computer is a Sun SPARCstation, SGI Indigo or Indy, Intergraph 2400 or 6400, or color NeXTstation.
1.Locate your monitor cable; it connects the monitor to the com- puter. Unplug it from the computer. Remember where you unplugged the cable from the computer, you will plug the LitePro cable into this same connector in the next step.
2.Attach one of the 13W3 adapters to the “Computer” end of the LitePro cable.
•If your computer is an SGI, plug the “SGI” end of the adapter into the “Computer” end of the LitePro cable. For other computers, use the “Other” connector.
3.Plug the adapter (with the cable attached) into the monitor con- nector on the computer.
4.Attach the other 13W3 adapter to the “Monitor” end of the LitePro cable.
•If your computer is an SGI, plug the “SGI” end of the adapter into the “Monitor” end of the LitePro cable. For other computers, use the “Other” connector.
5.Plug the adapter (with the cable attached) into the computer’s monitor cable.
6.Tighten the thumb screws on all the connectors to ensure proper grounding.
7.Turn on the monitor.
8.Turn on the LitePro 760 by pressing the “1” side of the power switch. (Refer to “Powering Up the LitePro” on page 15.)
9.Turn on the computer.
8 | LitePro 760 User’s Guide |
