1Turn off the projector and unplug the power cord.
2Wait 60 minutes to allow the projector to cool thoroughly.
3Remove the lamp door, located on top of the projector, by removing the screw on the side of the lamp door, sliding the door right, and lifting the lamp door off.
4Loosen the captive screws that attach the lamp housing to the projector. NOTE: If the projector is installed on a ceiling mount, be careful not to drop the lamp module once the captive screws are loosened.
5Carefully lift the lamp straight up, off of the alignment pins; being careful not to pinch the lamp connector. Dispose of the lamp in an environmentally proper manner.
6Install the new lamp module, aligning the pins properly. Be careful not to pinch the lamp connector.
7Tighten the screws. (NOTE: If the pins have not been aligned properly, the screws will not tighten securely.)
8Replace the lamp door by (a) putting the lamp door down and (b) sliding it until it locks.
9Replace the lamp door screw and tighten securely.
10Plug in the power cord and press the Power button to turn the projector back on.
11To reset the lamp hour timer, navigate to the Advanced Menu > Status/Service menu and select Reset Lamp Hours....
turn off and unplug projector
(Advanced Menu )
Image | Source Info... |
Setup | Projector Info... |
Status/Service | Reset Lamp Hours... |
| Factory Reset... |
Basic Menu | Service Code... |
wait 60 minutes
loosen screws
MDL: IN112a
FW: 0.14
33
