InFocus IN20 Series Turn on projector and source, Turn on the projector, Change source if needed

4 Turn on projector and source

1Connect the power cord to the projector

and to an electrical outlet

The green power light on the projector will turn on.

2Turn on the projector

Press power (on the projector or remote).

The power light will start blinking.

3Wait for the lamp to warm up

After a few seconds, the power light will stop blinking and stay on. It can take a minute for the lamp to reach full brightness.

5-10 sec.

Warning: Do not look directly into the lens when the projector is turned on.

4Turn on computer or other source

You may need to press a specific key combination to activate your laptop’s external video port. On most laptops, hold down the Fn key while pressing a key labeled CRT/LCD, LCD/VGA,

a monitor icon , or similar. Key combos for popular models:

Apple F7	Gateway Fn+F3 or Fn+F4	IBM ThinkPad Fn+F7
Dell Fn+F8	HP/Compaq Fn+F4 or Fn+F5	Toshiba Fn+F5
Fujitsu Fn+F10	Sony Fn+F7

Complete laptop activation chart at www.infocus.com/service

Important: If there is still no video, restart your i computer (first make sure it’s connected to the

projector and the projector is turned on).

5Change source if needed

If needed, press source (on the projector or remote) to view the source. You may have to press it more than once.