45537560_ed1 EN-1
EN
Product Safety Information
Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Air Impact Wrench Product Safety Information Manual Form
04580916.
Manuals can be downloaded from www.ingersollrandproducts.com.
Power Management System
For models that include a power management system, the system allows operator reduction of
maximum output power in the forward direction. The power management system does not aect the
output power in the reverse direction.
To adjust the power, rotate the Power Regulator to the desired level indicator.
The power level indicators are for reference and DO NOT indicate a specic power. The power output can
be further reduced in forward or reverse by using the variable throttle.
Product Specications
Models Style
Drive Impacts
per min.
Recommended Torque Range
Type Size Forward
ft-lb (Nm)
Reverse
ft-lb (Nm)
2015MAX Angle Square 3/8” 2100 45-140 [150 Max]
(61-190 [203 max])
45 - 160 [180 Max]
(61 - 217 [244 Max])
2025MAX Angle Square 1/2” 2100 45-140 [150 Max]
(61-190 [203 max])
45 - 160 [180 Max]
(61 - 217 [244 Max])
Models
Impacting Sound Level dB(A)
(ISO15744)
Free Speed Sound Level dB(A)
(ISO15744)
Vibration (m/s)
(ISO28927)
† Pressure (Lp) ‡ Power (Lw) Pressure Power Level *K
2015MAX 96.6 107.6 94.1 105.1 17.4 3.0
2025MAX 96.6 107.6 94.1 105.1 17.4 3.0
† KpA = 3dB measurement uncertainty * K = Vibration measurement uncertainty
‡ KwA = 3dB measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain condensate
from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install a properly sized Safety Air
Fuse upstream of hose and use an anti-whip device across any hose coupling without internal shut-o, to
prevent hose whipping if a hose fails or coupling disconnects. See drawing 47133707 and table on page
2. Maintenance frequency is shown in a circular arrow and dened as h=hours, d=days, and m=months of
actual use. Items identied as:
1. Air lter 5. Hose diameter 9. Oil
2. Regulator 6. Thread size 10. Grease
3. Lubricator 7. Coupling
4. Emergency shut-o valve 8. Safety Air Fuse
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and
parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Oce or Distributor.