OPERATOR’S MANUAL |
|
INCLUDING: OPERATION, INSTALLATION AND MAINTENANCE. | RELEASED: |
INCLUDE MANUALS: Form | REVISED: |
| (REV. D) |
| |
HIGH PRESSURE SPRAY GUN |
|
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
MAXIMUM WORKING PRESSURE 7500 P.S.I. (517.2 BAR)SERVICE KITS
Use only genuine ARO® replacement parts to assure compat- ible pressure rating and longest service life.
61240 for repair of spray gun.OPERATIONThe
For adjustments of the
1.To take slack out of the handle, adjust (8) set screw.
a.Loosen (9) nut.b.Adjust (8) set screw to obtain desired play or slack.
c.Tighten (9) nut.2.Should material leak from the lever end of the gun, re- move the lever and tighten (11) retainer. If this does not stop the leak, remove the retainer and replace the (13) packings.
3.Should you be unable to stop the flow of material from the extrusion gun, the (16) ball is probably not seating properly into the (3) ball seat. The ball should be removed and inspected for dirt or nicks. Also inspect the ball seat for dirt or nicks. If the ball or ball seat are damaged, they should be replaced. When pressing (3) insert and ball seat into place inside (18) body, make sure that the ball seat is facing in the proper direction. The material outlet of the insert must be in line with the outlet in the (18) body after being pressed into place.
EXTRUSION GUN
(less nozzle)
SPRAY GUN
(less tip)INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET
(800) | © 2011 | CCN 99711202 |
www.ingersollrandproducts.com |
|
|