OPERATOR’S MANUAL

 

6564X-X

 

 

6566X-X

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

 

 

6” AIR MOTORS

 

66620

6564X-X and 66620

6566X-X

RELEASED: 8-28-91

REVISED: 10-11-01

4” STROKE

6” STROKE

(REV. K)

 

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

THIS MANUAL COVERS THE FOLLOWING MODELS

65643

65645

MODEL

65662

65665￿2B

66620

65665￿B

65666

 

 

 

 

SERVICE KITS

61355 for general repair of all 6" air motors.

GENERAL DESCRIPTION

The 6" air motor is a general purpose power unit and is used with many 2￿ball, 4￿ball and chop check pumps. It utilizes tie rod type construction for easy breakdown and it connects to the various lower ends via tie rods for easy operation. Consult pump model operator's manual for specific instructions. It is recommended that a muffler be connected to the ex￿ haust port to reduce noise to acceptable OSHA standards.

Filtered and oiled air will allow the air motor to operate more efficiently and yield a longer life to operating parts and mechanisms. A filter capa￿ ble of filtering particles larger than 50 microns should be used with an oiler. Keep the oiler supplied with a good grade of S.A.E. no. 90W non￿ detergent gear oil, set at a rate not to exceed 1 or 2 drops per minute.

NOTICE

DO NOT OPERATE AIR MOTOR ABOVE RECOMMENDED AIR PRESSURE OF 150 P.S.I. (10.3 BAR) OR 75 CYCLES PER MINUTE. Air motor may be rated differently in the next assembly. Check model plate.

INGERSOLL-RAND COMPANY

P.O. BOX 151 D ONE ARO CENTER D BRYAN, OHIO 43506￿0151

& (419) 636-4242 D FAX (419) 633-1674 E2001 D PRINTED IN U.S.A.

Page 1
Image 1
Ingersoll-Rand 65665B, 66620, 65662, 656652B, 65643, 65645, 65666 manual Service Kits, General Description