E2010 CCN 15244957
(800) 276-4658 DFAX (800) 266-7016
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET -- BRYAN, OHIO 43506

1-1/2” DIAPHRAGM PUMP

OPERATOR’S MANUAL PD15E-XXX-XXX

RELEASED: 6-15-05
REVISED: 11-15-10
(REV. 05)
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

1:1 RATIO (CONDUCTIVE NON-METALLIC)

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.

SERVICE KITS

Refer to Model Description Chart to match the pump material options.
637389 for air section repair (see page 6).
637391-XX for fluid section repair (see page 4). NOTE: This kit also con-
tains several air motor seals which will need to be replaced.
637390-7 major air valve assembly (see page 7).

PUMP DATA

Models see Model Description Chart for “-XXX”...........
Pump Type Non-Metallic Air Operated Double Diaphragm.......
Material see Model Description Chart...........
Weight 43.14 lbs (19.57 kgs).........................
Maximum Air Inlet Pressure 120 p.s.i.g. (8.3 bar).........
Maximum Material Inlet Pressure 10 p.s.i.g. (0.69 bar).....
Maximum Outlet Pressure 120 p.s.i.g. (8.3 bar)..........
Maximum Flow Rate (flooded inlet)123.1 g.p.m. (465.9 l.p.m.)....
Displacement / Cycle @ 100 p.s.i.g. 0.617 gal. (2.34 lit.)...
Maximum Particle Size 1/4” dia. (6.4 mm)............
Maximum Temperature Limits (diaphragm / ball / seal material)
E.P.R. / EPDM -60_to 280_F(-51_to 138_C)...........
HytrelR-20_to 150_F(-29_to 66_C)................
Nitrile 10_to 180_F(-12_to 82_C).................
Polypropylene 35_to 175_F(2_to 79_C)...........
SantopreneR-40_to 225_F(-40_to 107_C)...........
PTFE 40_to 225_F(4_to 107_C).................
VitonR-40_to 350_F(-40_to 177_C)................
Dimensional Data see page 8................
Mounting Dimension 8.687” x 14.937” (220.7 mm x 379.4 mm)...
Noise Level @ 70 p.s.i., 60 c.p.m. 81.0 db(A){.....
The pump sound pressure levels published here have been updated to an Equivalent
Continuous Sound Level (LAeq) to meet the intent of ANSI S1.13-1971, CAGI-PNEU-
ROP S5.1 using four microphone locations.
NOTICE: All possible options are shown in the chart, however, certain
combinations may not be recommended, consult a representative or the
factory if you have questions concerning availability.
PD15E-FES-PXX Figure 1

MODEL DESCRIPTION CHART

PD15 E -F E S -P X X
PD15E - FES - P X X
637391 - X X
DiaphragmBall
FLUID SECTION SERVICE KIT SELECTION
EXAMPLE: Model # PD15E-FES-PAA
Fluid Section Service Kit # 637391-AA
Seat Material
P - Polypropylene
Diaphragm Material
A - Santoprene T - PTFE / Santoprene
C - Hytrel V - Viton
G - Nitrile
Hardware Material
S - Stainless Steel
Fluid Caps & Manifold Material
E - Conductive Polypropylene
Fluid Connection / Location
F - 1-1/2” A.N.S.I. / DIN Flange / End
Center Section Material
E - Conductive Polypropylene
Ball Material
A - Santoprene T - PTFE
C - Hytrel V - Viton
G - Nitrile
www.ingersollrandproducts.com