Form P7648
Edition 1
August 2004
CCN 04579728
Operation and Maintenance Manual
for
Series SRV125F
Starter Relay Valve
NOTICE
Series SRV125F Starter Relay valves are designed for controlling fluid flow in conjunction with Air Starting Systems.
WARNING
•IMPORTANT SAFETY INFORMATION ENCLOSED - SAVE THESE INSTRUCTIONS.
•Read and understand this manual before operating Valve.
•Failure to observe the following warnings could result in injury.
PLACING THE VALVE IN SERVICE
•Always install, operate, inspect and maintain this prod- uct in accordance with all applicable standards and reg- ulations (local, state, country, federal, etc.).
•Always use clean, dry air at a pressure which does not exceed the pressure rating listed on the valve.
•Do not use damaged, frayed or deteriorated air hoses & fittings.
•Always turn off the air and disconnect the air hose before installing, removing or adjusting any accessory on this valve, or before performing any maintenance on this valve or accessory.
•Do not lubricate the valve with flammable or volatile liquids such as kerosene, diesel or jet fuel, use only recommended lubricants.
•Series SRV125F Valves are not designed for working in explosive atmospheres.
•Do not remove any labels, replace any damaged labels.
•Operate this valve only when properly installed in the Air Starting System.
•Always bleed off the air pressure before attempting to remove the Starter Relay Valve from the Receiver or before attempting to perform any maintenance on the Starter Relay Valve.
•Never attempt to remove the Retaining Ring (12) from the bottom side of the Starter Relay Valve until the air pressure has bled off. If the Retaining Ring is removed while there is pressure in the Receiver, internal parts of the Starter Relay Valve will be blown out with consid- erable force.
•Use only recommended
Refer All Communications to the Nearest
©
P7630 Edition 1
Printed in U.S.A
