13
Insignia 46"/55" 1080p LED TV
www.insigniaproducts.com
Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2Connect a coaxial cable to the ANT/CABLE jack
on the back of your TV and to the antenna or
cable TV wall jack.
3Plug your TV’s power cord into a power outlet,
then turn on your TV.
4Go through the Setup Wizard on page 21.
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1Make sure that your TV’s power cord is
unplugged and the DVD or Blu-ray player is
turned off.
2Connect an HDMI cable (not provided) to one of
the HDMI jacks on t he side of you r TV a nd to th e
HDMI OUT jack on the DVD or Blu-ray player.
3Plug your TV’s power cord into a power outlet,
then turn on your TV.
4Turn on the DVD or Blu-ray player, then set it to
the correct output mode. For more information,
see the documentation that came with the
player.
5Press INPUT to open the Input Source list.
6Press S or T to highlight HDMI1, HDMI 2,
HDMI3, or HDMI 4 then press ENTER.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak , the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster or
cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact your
cable or satellite TV provider about upgrading to
a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally recorded
in HD.
Y / VIDEO
P
B
P
R
L R
Coaxial cable
Antenna or
cable TV (no box)
Back of TV
Note
You can also press HDMI repeatedly to select the
DVD or Blu-ray player.
DVD or Blu-ray player
HDMI cable
Side of TV