18
NS-46D400NA14/NS-50D400NA14 Insignia 46/50" LED TV
www.insigniaproducts.com
Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1Make sure that your TV’s power cord is unplugged and all connected equipment is turned off.
2Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the antenna or
cable TV wall jack.
3Plug your TV’s power cord into a power outlet, then turn on your TV.
4Press INPUT to open the INPUT SOURCE list.
5Press S or T to select TV, then press ENTER.
6If you cannot tune to channels you know exist, scan for channels. See “Autom atically scanning for channels” on
page 46.
Coaxial cable
Antenna or cable TV
(no box)
Back of TV
Coaxial cable
connector
ANT/CABLE IN
jack
On your TV
Notes
Use a coaxial cable to eliminate interference and noise from radio
waves.
Do not bundle the coaxial cable with the power cord or other cables.
If the antenna is not installed correctly, contact qualified service
personnel to correct the problem.
If the signal level for a channel is weak, the picture may be distorted.
Adjust the antenna or use a highly directio nal outdoor or set-top
antenna with a built-in amplifier.
If the picture quality is good on some channels and poor on others, the
problem may be caused by a poor or weak signal from the broadcaster
or cable TV provider.
If you connect to cable or satellite TV without a set-top box and
experience poor picture quality, you may need to install a set-top box to
improve signal reception and picture quality. Contact your cable or
satellite TV provider about upgrading to a set-top box.
Many high-definition (HD) channels upscale standard-de finition (SD)
content. The picture displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as it would be if the
content was originally recorded in HD.