44
NS-50L440NA14 Insignia 50" LCD TV
www.insigniaproducts.com
Changing channel settings

Automatically scanning for channels

When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press
CH or CH , your TV goes to the next or
previous channel in the channel list.
If the TV signal source changes, for example you
change from an outdoor antenna to cable TV (no
box), you need to scan for channels.
To automatically scan for channels:
1Press MENU. The on-screen menu opens.
2Press W or X to highlight CHANNELS, then press
T or ENTER. The CHANNELS menu opens.
3Press S or T to highlight Auto Channel Search,
then press ENTER. The CHANNELS· AUTO
CHANNEL SEARCH screen opens.
4Press S or T to highlight Antenna, Cable, or
Satellite Box, then press ENTER.
AIf you select Antenna, your TV scans for
available channels. The scan may take
several minutes.
BIf you select Cable, a message asks if you
have a cable box:
• Select No, then press ENTER if no cable
box is connected. Your TV scans for
available channels. The scan may take
several minutes.
• Select Ye s, then press ENTER if a cable box
is connected. A message asks how you
connected the cable box to your TV:
• Select HDMI, Component, or AV, then
press ENTER if you connected a cable
box to your TV using one of these
cables. Read the message, then press
ENTER to close the wizard.
• Select Coax ial, then press ENTER if you
connected a cable box to your TV using
a coaxial cable. Read the message, then
press ENTER to start the channel scan
(VHF channels only).
Note
You can press EXIT to stop the auto
channel search, but you will need to run
the auto channel search again to create a
channel list.
Note
You can press EXIT to stop the auto
channel search, but you will need to run
the auto channel search again to create a
channel list.