Insignia NS-A2110 Troubleshooting, REPEAT, REPEAT, Problem, Solution, Possible cause, To repeat an entire program:

Insignia NS-A2110 Executive Shelf System

To repeat an entire program:

1Press REPEAT twice while the program is playing.

2To cancel repeat, press REPEAT again.

Troubleshooting

Caution

Do not try to repair the shelf system yourself. Doing so will invalidate your warranty.

Problem	Possible cause	Solution
No sound or	Volume too low.	Turn up the volume.
power
	AC power cord not securely	Connect the AC power cord.
	connected.
The CD does	The CD was incorrectly	Reinsert the CD, label side up.
not play	inserted.
	The CD is defective.	Try another CD.
	The CD compartment is not	Close the CD door.
	closed.
	There is condensation in the	Remove the CD and leave the
	CD compartment.	cover open for about an hour in a
		dry environment.
No disc	No CD inserted.	Insert a CD, CD-R, or CD-RW disc.
indicated on the
	The CD is badly scratched or	Clean the CD if it’s dirty. Replace
display	dirty.	the CD if it’s defective.
	There is condensation in the	Remove the CD and leave the
	CD compartment.	cover open for about an hour in a
		dry environment.
	You are using a CD-R or	Use a finalized CD-R or CD-RW.
	CD-RW that is blank or the
	disc has not been finalized.
No sound in the	The headphone jack is not	Reinsert the headphone plug into
headphones.	correctly inserted.	the jack.
	The volume control is turned	Increase the volume.
	down.
	The CD is defective.	Try another CD.
The CD skips	The CD or lens is dirty.	Clean or replace the CD, or clean
during play.		the lens.
	Strong shaking or vibrations	Place the shelf system on a flat and
		stable surface without vibration.
	The CD player is programmed	Quit the Program mode.
	to skip a track.

12www.insignia-products.com