Insignia NS-C2116 CD Clock Radio

Setting up your CD clock radio

Using AC power

To use AC power:

1Make sure that your local AC power source matches the voltage shown on the plate located inside the battery compartment (120 V 60 Hz). If it does not, consult your dealer or service center.

2Connect the power cord to the AC connector on the CD clock radio, then plug it into an AC power outlet.

3To switch the CD clock radio off completely, unplug the power cord from the AC power outlet.

Caution

To protect your CD clock radio during heavy thunderstorms, unplug the power cord from the AC power outlet.

Using battery backup

Your CD clock radio has a battery backup feature that continues to operate the electronic clock if the AC cord is disconnected or if there is a power failure. The clock operates internally, with no display.

Check the condition of the battery periodically by disconnecting the AC cord and reconnecting it again several minutes later. The clock should maintain the correct time, even when the power is disconnected. During a power outage, if the power is not restored for longer than 30 minutes, the battery must be replaced and the time reset.

To install the battery:

•Open the battery compartment and insert a 9V battery, preferably alkaline. Make sure to match the polarity indicated by the “+” and “-” markings on the snap-on battery terminal.

Caution

Incorrect use of batteries can cause electrolyte leakage and can corrode the compartment or the batteries. To prevent this damage:

•Use only the size and type of battery specified in this guide.

•Remove the battery if the CD clock radio will not be used for an extended period of time.

•Do not try to recharge a non-rechargable battery. The battery can overheat and rupture.

10www.insignia-products.com