Getting started

Setting the clock

1Press and hold the TIME SET button on the back of your clock radio. The time blinks on the LCD.

2Press MIN (minute) to set the minutes and HOUR to set the hours. Make sure that you set AM/PM correctly.

3Press TIME SET again. The clock is set.

Turning your clock radio on and off

1Press and hold /SOURCE for two seconds. Your clock radio turns on.

2Press DIMMER on the back of your clock radio to set the display backlight of the LCD to a comfortable level.

3Press and hold /SOURCE again to switch your clock radio to standby mode.

Using Voice Command

1Turn the VC button to ON on the back of the radio. To activate the voice controls, say “Voice Command” to the clock radio or press the SNOOZE/ SLEEP/ VOICE COMMAND button. The clock will respond “What can I do for you?.”

TIPS:

•Speak clearly and in a normal tone.
•Give correct commands (refer to command list below).
•Do not give commands when the clock radio is speaking.
•Speak near the microphone located on the top of the clock radio.
•Commands must be spoken in non-accented English.

2Say any of the following commands for the function you want, then follow the voice prompts carefully:

•Time (”tīm”)
•Set Time (”set tīm”)
•Alarm (”e-’lärm”)
•Set Alarm (”set e-’lärm”)
•Sleep Time (”slēp tīm”)
•Radio (”rā-dē-ō”)
•Help (”help”)
•Cancel (”kan(t)-sel”)

[Pronunciation guide derived from online Merriam-Websterdictionary at www.merriam-webster.com.]

For additional information on using voice control, refer to the User Guide.

Setting and using the alarm manually

1Press and hold the ALARM 1 or ALARM 2 button (depending on which alarm you want to set) until the display blinks.

2Press HOUR to set the hour you want to wake up, then press MIN (minute) to set the minute. Make sure you set AM/PM correctly.

3Briefly press ALARM 1 or ALARM 2 again to save the setting. The display stops blinking.

4To cancel the alarm, press ALARM 1 or ALARM 2 again until the alarm indicator disappears from the display.

Playing the radio

1Press and hold the /SOURCE button for two seconds to turn on your clock radio.
•Press the /SOURCE button repeatedly to select the AM or FM band.

•If you are listening to FM, uncoil and extend the FM antenna on the back of your clock radio and move it around to improve reception.

-OR-
If you are listening to AM, turn the radio slightly to improve reception.•Press TUNE + or TUNE - to tune the radio to a higher or lower frequency.

•Press and hold TUNE + or TUNE - for more than one second to scan to a higher or lower frequency. The radio automatically scans to the next station.

•Press the VOLUME UP or VOLUME DOWN buttons to increase or decrease the volume. Adjust the volume to a comfortable level.

2Press and hold the /SOURCE button to turn off your clock radio.

Listening to an external sound source

1Make sure that your clock radio is turned off.

2Connect the external sound source to the AUX IN jack on the back of your clock radio using a stereo 3.5 mm plug cord (not supplied).

3Press and hold the /SOURCE button for two seconds to turn on your clock radio.

4Press the /SOURCE button repeatedly to select AUX. “AUX” appears on the display.

5Start playback on the external sound source, then adjust the volume to a comfortable level. Control playback on the external audio device.

Specifications

 

Frequency range

Bands: FM and AM

 

Range: FM - 87.5~107.9 MHz (200 KHz steps)

Station presets

AM - 530~1710 KHz (10 KHz steps)
FM - 5
External connections
AM - 5
3.5 mm stereo

Volume

0-16 levels

Speakers

2 x 2" - 4 ohm full range

Power

2W x 2 RMS
AC power adapter - 110V 60Hz to 9V,1A

 

DC - 3 x AAA batteries for memory backup

Troubleshooting

For information on troubleshooting, refer to the User Guide.

FCC Part 15

This device complies with Part 15 of the FCC Rules.

FCC warning

Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user’s authority to operate this equipment.

ICES-003 Class B Notice

This Class B digital apparatus complies with Canadian ICES-003.

© 2010 BBY Solutions, Inc. All rights reserved. INSIGNIA is a trademark of BBY Solutions, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners.

ENGLISH 10-0131