Insignia NS-FSDVD Using your player, Connecting a TV with S-Video, Connecting a TV with component video, Turning your player on or off, Using the remote control

Insignia NS-FSDVD DVD Player

Connecting a TV with S-Video

To connect a TV with S-Video:

1Connect an S-Video cable to the S-Video Out jack on the back of your TV and to the S-Video In jack on the TV.

Back of player
S-Video cable
Audio cable	TV

2Connect an audio cable to the MIX L/R jacks on the back of your player and to the AV AUDIO IN jacks on the TV.

3Turn on your player. The default TV video type is set to S-Video. If you have changed the TV video type, press PSCAN/NORMAL to select S-VIDEO.

4Turn on the TV, then select the appropriate input source. For more information, see the documentation that came with the TV.

Connecting a TV with component video

To connect a TV with component video:

1Connect a component video cable to the YPbPr jacks on the back of your player and to the Component In jacks on the TV.

Back of player	Component video
	cable

Using your player

Turning your player on or off

Warning

When your player is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord.

To turn your player on or off:

1Press Power. Your player turns on.

2Press Power again to turn off your player.

Using the remote control

•Point the remote control toward the remote control sensor on the front of your player.

•Make sure that no objects are between the remote control and the remote control sensor.

•Do not expose the remote control to shock.

•Do not expose the remote control to liquids or high humidity.

•Do not place your player in a location where sunlight or bright light shines on the remote control sensor. This can interfere with the signal from the remote control.

The following illustration shows the best angle for using the remote control.

19.7ft. (6 m)

30°

30°

Audio cable TV

2Connect an audio cable to the MIX L/R jacks on the back of your player and to the AV AUDIO IN jacks on the TV.

3Turn on your player, then press PSCAN/NORMAL to select P-SCANor Interlace. If the TV is a high-definition or progressive scan capable TV, select P-SCAN. If the TV is an older, “analog” TV, select Interlace.

4Turn on the TV, then select the appropriate input source. For more information, see the documentation that came with the TV.

Selecting the video output mode

You need to set the video output mode on your player to match the TV video type. If you connect

aTV using the S-Video jack, select S-VIDEO. If you connect a TV using the component jacks, select P-SCANif the TV is a high-definition or progressive scan capable TV or select Interlace if the TV is an older, “analog” TV.

To select the video output mode:

1Press SETUP. The on-screen menu opens.

SYSTEM SETUP

TV SYSTEM

SCREEN SAVER

VIDEO

TV TYPE

PASSWORD

RATING

DEFAULT

LAST MEMORY

2Press or to select VIDEO, then press

ENTER.

3Press or to select the TV video type, then press ENTER.

4Press SETUP to close the menu.

www.insignia-products.com 5