Insignia
Setting up your LCD TV/DVD |
| outside antenna jack. |
| 3 Plug the other end of the cable into the | |
combo |
|
|
|
| Notes |
Installing remote control batteries |
| To improve picture quality in an area with poor |
| signal reception, install a signal amplifier. | |
|
| |
To install remote control batteries: |
| If you want to connect two TVs to the antenna, |
| install a | |
1 Remove the battery compartment cover. |
| |
|
| |
|
| |
2Insert two AA batteries into the battery compartment. Make sure that you align the + and – symbols on the batteries with the + and
– symbols inside the battery compartment.
3Replace the battery compartment cover.
Notes
Make sure that there is no obstruction between the remote control and the remote sensor on your LCD TV/DVD combo.
Keep the remote control away from heat sources or humid areas.
Strong light may affect the signal between the remote control and the remote sensor on your LCD TV/DVD combo. If the remote control does not work, change the position of the remote control.
Make sure that the batteries are alkaline batteries. Batteries must be of the same type.
Do not mix old and new batteries. Do not use rechargeable batteries.
Connecting an antenna
Caution
Do not bend the bronze wires on the cables.
To connect an antenna:
1Make sure that your LCD TV/DVD combo is turned off.
2Plug one end of a 75 ohm cable (not included) into the ANT IN jack on the back of your LCD TV/DVD combo.
Connecting cable or satellite TV
To watch cable or satellite TV, you need a TV tuner device or a cable or satellite TV converter box.
There are two ways to connect cable or satellite TV to your LCD TV/DVD combo.
Option 1
Caution
Do not bend the bronze wires on the cables.
To connect cable or satellite TV:
1Make sure that your LCD TV/DVD combo and converter box are turned off.
2Connect a 75 ohm cable (not included) to the RF jack on the cable or satellite TV converter box and to the ANT IN jack on the back of your TV.
3Connect one end of a 75 ohm cable (not included) to the cable jack on the cable or satellite TV converter box and to the cable or satellite TV wall jack.
4Set the channel switch on the cable or satellite TV converter box to 3 or 4.
5Turn on your LCD TV/DVD combo and the converter box, then tune your LCD TV/DVD combo to the same channel you set the channel switch to.
6Use the cable or satellite TV remote control to tune channels.
Option 2
To connect cable or satellite TV:
1Make sure that your LCD TV/DVD combo and cable or satellite converter box are turned off.
2Connect audio and video out jacks on the cable or satellite TV converter box to the AUDIO IN and VIDEO IN jacks on the back of your TV.
3Turn on your LCD TV/DVD combo and the converter box, then press INPUT to select TV.
5 |