InStep 11-BA102, 11-BA101 manual Proper USE of Seat Belts & Shoulder Straps

Operating Instructions Run Around™ 11-BA101, 11-BA102...page 3

Front Fender Assembly

Insert the #8 – 1.5" screws into the holes located on the front support above the wheel. Align the holes on the bottom side of the fender with the screws and tighten with a Phillips screwdriver.

Parent Console

The parent console will attach to the push handle. It will snap in place above the canopy and below the foam hand grip.

Tether Attachment

The wrist strap has different sized loops. The large loop will go on your wrist; the small loop will be on handlebar. Slide end with large loop through the small loop, then grasp the end with the large loop and pull strap to tighten on handlebar.

Caution: Whenever child is in stroller always use the wrist strap. Before you remove the wrist strap from your wrist make sure you first engage the rear brakes.

Rear Parking Brakes:

Step on the levers next to the rear wheels until the cogs of the brakes engage the cogs of the wheel. Repeat on other side. To release brake, lift levers using your toe until cogs disengage.

Front Caliper Brake:

The front brake operates the same as a bicycle hand brake. Squeeze lever located on handlebar to engage front brake. Release lever to disengage.

PROPER USE OF SEAT BELTS & SHOULDER STRAPS

WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt.

Place child in seat. Make sure T-shield is between the child’s legs. When child is seated, place shoulder straps over the child’s shoulders. Slide waist straps through lower loops of shoulder straps, bring lap belt ends together and clip into place around child’s waist. Adjust waist and shoulder straps for snug fit.

To recline seat

To fully recline, unhook buckle on back of the seat.To adjust the recline position; adjust the slide on the strap to the desired length.

WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position unless T-shield and shoulder strap have been readjusted to the new seat position.

Storage and folding

WARNING: Always remove child from stroller before folding

Pull the back of the seats forward. It will be easier to fold if the seats are not in the recline position. Remove locking pins from side latches on the stroller frame (Double Models have 2 locking pins). Release the two latches from the frame. The stroller may automatically begin to fold, the front wheel will fold under frame and the handle will fold backwards.

Storage and folding

M3_single_Platform.indd 4

9/26/05 3:57:45 PM