Model M3 Strollers Assembly Instructions
Parts List
Description | Qty |
Frame Assembly | 1 |
Fender | 1 |
Fender screws # 8 x 3/4" | 4 |
Parent Console | 1 |
Front Wheel Assembly 16" | 1 |
Rear Wheels 16" | 2 |
Stroller Assembly Instructions
Step 1. Unfold Stroller
Grasp frame as shown and open until both side latches engage (Figure A).
Step 2. Rear Wheel Assembly
Turn stroller onto its side. Grasp rear wheel in one hand, slide wheel’s axle into the sides of the rear “ U “ shaped crossbar hole located near the rear brake. Push firmly to lock in place. (Figure B1). Check to
see that the wheel is properly inserted by pulling on the wheel firmly. The wheel should not come off if fully inserted/locked. Repeat for other side. To release wheel push up on axle release lever and pull off wheel (Figure B2).
Rear Axel
Axel Hole | Fig. B1 |
Step 3. Front Fender Assembly
Turn stroller upright onto its rear wheels, then tip stroller back so the handlebar is down on the ground and the front fork is up. Align the fender’s
4 boss’s with the 4 holes on the front frame push the 4 boss’s into the frame’s hole. Insert the
#8 x 3/4" screw into the hole and tighten with a Phillips screwdriver, repeat for the other 3 holes (Figure C).
Fig. A
Release Lever
Fig. B2
Boss
Front Fender Holes
