InStep RS100 For Model CS300 Only, Stroller Assembly Instructions, Parts List, Unfold Stroller

IMPORTANT

We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with your selection. Great care and effort has been taken, however occasionally problems may occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer questions, please contact us at either our Toll-Free Customer Service Number or Email us at our number list- ed below. Service will be quicker if you have your model number (found on the product and box) along with this instruction sheet ready when calling. If you have any questions concerning the safe use of this product, please contact us 1-800-242-6110 press “1” for customer service and then “2” to speak to a representative or Email us at info@instep.net or visit our web site at www.instep.net.

For Model CS300 Only

Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 20-25 PSI maximum. 25 PSI will provide a comfortable ride for your child.

Parts List

Description	Qty.
Frame Assembly	1
Front Wheel Assembly (Dual wheels)	2
Rear Wheel	2
Rear Axle Assembly	1

Description	Qty.
Rear Wheel Kit consists of:
Rear hub/brake cog	2
Rear axle retaining clip	2
Rear axle cap	2
Rear wheel hub cap	2

Stroller Assembly Instructions

Step 1. Unfold Stroller

Release storage latch located on side of stroller (Figure A). Grasp frame as shown and open until side latches engage (Figure B).

Step 2. Front Wheel Assembly

Turn stroller on its side. Slide the front wheel assembly onto one of the front legs. Push until the wheel assembly locks into place. Repeat for other side (Figure C1). Pull firmly on each wheel assembly to ensure that they are securely attached. Note: to remove front wheels, press the tab located beneath wheel assembly (Figure C2).

B C1

Side Latch

Front Leg

A Storage Latch

Swivel Lock C2

Wheel

Release

Tab

Front Dual Wheel

2