mP4G/mP4GL Series Motherboard

Note:

You must install the supplied USB 2.0 drivers for use with Windows 2000 or Windows XP or the USB ports will only work in USB

1.1mode. Other operating systems are not supported.

USB Ports:

There are three USB ports on the rear panel. The JUSB3 USB port shares a root hub with the third external USB port.

USB Ports

Function: Connecting USB 2.0 devices to the system.

Description: These are Hi-Speed USB 2.0 ports for connecting either USB 1.1 or 2.0 devices. The ports are for “Type A” USB cable connectors. You can connect or disconnect USB cables when the system is turned on.

More Information: See the Integrated Peripherals section of “Configuring the CMOS Setup Utility” in Chapter 5 for information on adjusting port settings.

USB ports 1, 2, 3

LAN RJ-45 Jack:

Right LED = Activity

Left LED = Link

LAN Port

Function: Connecting a CAT 5 LAN cable to the system.

Description: This is an RJ-45 connector for standard Cat 5 LAN cabling with RJ-45 jacks. The connector is for the optional onboard LAN controller. You can connect or disconnect a LAN cable when the system is turned on.

More Information: See the System Features section of Chapter 6 for information LED modes.

RJ-45 LAN jack

2•20

User’s Manual