Intel 6007002463A20, IP-4GVI63 Series

Installations

Removing a CPU:

1. Before removing the CPU, turn off the IP-4GVI63 Series power; then wait

for about 20 minutes until the heat radiation plate of the cooling fan and

the CPU cools down.

2. To remove the CPU, lift the releasing lever of the Socket 478.

Note: The CPU and the heat radiation plate are hot. They may cause

burns.

To remove the CPU, reverse the installation steps.

2.1.2 Heat Sink & Retention Module Installation

Make sure that good contact is made between the processors and the

heat sinks & fan. Insufficient contact, incorrect types of heat sinks, fans, or

thermal compound used or improper amount of thermal compound applied

on the CPU die can cause the processors to overheat, which may crash the

system.

Figure 4: Heat Sink & Retention Module Installation

Heat Sink & Fan

(For P4 processor only) Installation

Retention Module

(For P4 Heat Sink & Fan)