Mainboard PM945GC(V2.0)

Printer Interface Header: PARALLEL (Optional)

This mainboard provides a PARALLEL header for you connecting an additional printer connector on your case back panel. Attach the cable of printer connector (Optional) onto this header, and then you can use the printer connector connecting with a printer.

Keyboard/Mouse & USB Power On function Header: JP1

PS/2 Keyboard and PS/2 Mouse attached to the back panel can awaken the system from sleep mode. In order to enable this functionality, you must adjust the jumper caps on JP1 header as the table below.

 

JP1

Assignment

1

 

KB/MS & USB Power ON Disable (Default)

Pin 1-2 Closed

 

 

 

1

 

KB/MS & USB Power ON Enabled

Pin 2-3 Closed

 

 

 

Note: Close stands for putting a jumper cap onto two header pins.

USB Power On function Header: JP3

USB devices attached to the back panel USB ports can awaken the system from sleep mode. In order to enable this functionality, you must adjust the jumper cap on JP3 header for +5V or +5VSB mode depending on which USB port that the USB device is attached to.

JP3

Assignment

Assignment

+5V USB Power On Disable (Default)

Pin 1-2 Closed

+5VSB USB Power On Enabled

Pin 2-3 Closed

Note: Close stands for putting a jumper cap onto two header pins.

13