Interact-TV 44028 instruction manual Installing Batteries, Choosing Your Flying Location

INSTALLING BATTERIES

The Duck has a built-in, non-removable, non-replaceable, rechargeable capacitor. The charger is built into the Shooter and requires 3 “AAA” alkaline batteries (sold separately). Use only the supplied charger provided in this iFly DUCK HUNTER package to charge the Duck. DO NOT USE ANY OTHER SOURCE TO CHARGE THE DUCK. Install the batteries as shown.

CHOOSING YOUR FLYING LOCATION

Do not fly your Duck during windy conditions or harsh weather.	operating your iFly DUCK HUNTER near power-lines, trees, or
You can operate your iFly DUCK HUNTER toy indoors or	roof-tops. If flying your Duck indoors, the area should be
outdoors. The outdoor space should be roughly 32’ x 32’ (10m	roughly 16’ x 16’ (5m x 5m) and the standard household ceiling
x 10m) with a height allowance of about 19’ (6m). Avoid	height.

FLYING AND HUNTING YOUR IFLY DUCK HUNTER

1. Open the battery compartment door		2. Insert the 3 AAA batteries according to	3. Replace the battery compartment door
located at the upper rear of the Shooter		the picture (shown). Ensure that the +	and tighten the screw using the
by using	a Philips screwdriver (not	and – polarities match the illustrations	screwdriver. Do not over tighten.
included).		inside the battery compartment.

CHARGING THE ifly DUCK HUNTER

The Duck requires 10 seconds of charging time for a flight-time of 30 to 40 seconds. Charging the Duck is a simple process as outlined in the following steps.

The Duck is ready to fly as soon as it is finished charging. The objective of the iFly DUCK HUNTER game using single or multiple player mode is to shoot down the Duck with the Shooter within its 30 to 40 second flight time window. It takes 3 direct hits to bring down the Duck.

1.When you are ready to fly your fully charged Duck you should first adjust the “direction of flight” setting to the fly pattern of your choice. This is done by pivoting the directional control tab to the left, center, or to the right. The directional control tab is located at the dorsal (upper) rear end of the Duck’s body and has the two main wings attached to it. By pivoting the directional control tab to the left, the Duck will fly to the left and by pivoting the directional control tab to the right, the Duck will fly to the right. When the directional control tab is positioned in the center, the Duck will fly straight. The farther the directional control tab is pivoted towards a certain side, the more the Duck will bank towards that direction during its flight.

DIRECTIONAL CONTROL TAB

DIRECTIONAL CONTROL TAB

OFF ON

1. Turn the Duck’s ON/OFF switch to the	2. Turn the Shooter’s ON/OFF switch to	3. Lift the charge-rod located at the top
OFF position for charging.	the ON position for charging.	front of the Shooter to the up position.

2.Move the duck’s ON/OFF switch to the ON position. The wings will start to flap.

3.Gently toss the Duck into the air. It will fly for about 30 to 40 seconds.

4.To fire at the Duck, it is necessary to reload the Shooter. Reloading the Shooter is done by sliding the pump all the way backwards and forwards. A reloading sound is heard if this process is done successfully. Note: it is necessary to reload the Shooter after each shot fired. Once the Shooter is reloaded, you can fire a narrow infra-red beam at the Duck by pressing the trigger button on the Shooter. A firing sound is heard.

LEC Light

• If your shot misses the Duck, the Duck will continue to fly in it’s pre-determined path.

• If your shot hits the Duck, it will stop operating for a brief moment and appear to fall. This is meant to

simulate a glancing blow to the Duck. The Duck will resume its flight right away.

• Reload the Shooter and shoot at the duck again.

• When you shoot the Duck directly for the second time, the Duck will appear to temporarily fall again.

4.Locate the charge hole on the bottom side of the Duck and insert the Shooter’s charge rod completely. The Duck will sit on the Shooter snugly.

5.Press and hold the charge button located in the trigger area of the Shooter for about 10 seconds.

The green LED charge light located near the charge rod on the Shooter will light up during charging.

6.Release the charge button after 10 seconds of charging the Duck. The green LED charge light will turn off. Remove the Duck from the charge rod on the Shooter.

Normal flight will resume again momentarily.

• Reload the Shooter and shoot at the Duck again.

• When you shoot the Duck directly for the third time, it will fall from the sky.

Congratulations on your marksmanship!

• If you are unable to hit the Duck three times with the narrow infra-red beam of your Shooter the Duck

will land on the ground naturally.

WARNING! DO NOT CHARGE FOR LONGER THAN 10 SECONDS. DAMAGE MAY OCCUR TO THE CAPACITOR INSIDE THE ifly DUCK HUNTER.

7. The Duck is now ready to fly. The	8. Leave the Shooter’s ON/OFF switch in the ON position
charge is maintained until the ON/OFF	after charging the Duck. Press the charge rod down on the
switch on the Duck is set to the ON	Shooter after charging. In the down position, the charge
position. This handy feature allows you to	rod is an integral part of the target sighting system.
fly your Duck when YOU are ready!

5. When Duck has been shot down or has landed on its own,	6. If you are finished playing, make sure to turn the ON/OFF
turn it OFF to recharge it before playing again. Turning the Duck	switches on the Duck and on the Shooter the OFF position for
OFF resets the system. It is not necessary to turn the Shooter	storing. It is best to remove the batteries from the Shooter if it
OFF before recharging the Duck. To recharge the Duck, follow	will be stored for a longer period of time.
the steps outlined under “Charging the iFly DUCK HUNTER”.