ElevatedToilet Seat
Assembly, Installation and Operating Instructions
Model No. 1384
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact Dealer/Carrier for further instruction.
SAFETY SUMMARY
The following recommendations are made for the safe installation of the Elevated Toilet Seat:
GENERAL WARNINGS
DO NOT install this equipment without first read- ing and understanding this instruction sheet. If you are unable to understand these Warnings, Cau- tions and Instructions, contact a healthcare pro- fessional, dealer or technical personnel if appli- cable before attempting to install this equipment - otherwise, injury or damage may occur.
Always check to make sure that the Elevated ToiletSeatisproperlyandsecurelylockedinplace before using.
Ensure that all four (4) mounting brackets are ad-
Be sure to center your weight on the Elevated Toilet Seat because the seat may tip if you lean too far forward or to either side.
Users with limited physical capabilities should be supervised or assisted when using the Elevated Toilet Seat.
The Elevated Toilet Seat has a recommended weight limitation of 250 lbs.(114 kg.).
SEAT INSTALLATION (FIGURE 1)
NOTE: Refer to the GENERAL WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Remove contents from the carton.
NOTE: There are three (3) height adjustment positions. The Elevated Toilet Seat is shipped in the middle position.
2.Remove two (2) horizontal mounting bolts and ad- just bracket to desired height. Finger tighten only. Repeat for remaining three (3) brackets.
3.Visually inspect that all four (4) mounting brackets are adjusted to the same height.
4.Loosen vertical mounting bolt with wrench provided.
5.Position adjustable elevated toilet seat onto toilet bowl.
6.Twist or pivot each mounting bracket against toilet bowl rim.
7.After all four (4) mounting brackets have been posi- tioned properly, securely tighten ALL mounting bolts.
Elevated
Toilet Seat
Vertical
Horizontal | Mounting | |
Mounting | ||
Bolts | ||
Bolts | ||
| ||
| Mounting | |
| Brackets |
Toilet Bowl
FIGURE 1 - SEAT INSTALLATION/REMOVAL
SEAT REMOVAL (FIGURE 1)
NOTE: Refer to the GENERAL WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1.Loosen horizontal mounting bolts on all four (4) mounting brackets.
2.Lift up Elevated Toilet Seat off of the toilet bowl.
CLEANING PROCEDURES
WARNING
DO NOT use an abrasive detergent, cleaner or cloth to clean/dry the Elevated Toilet Seat.
1.Use a
2.Rinse with warm water and wipe dry with a
OVER
