11. Attach bed ends to head and foot spring assemblies.

NOTE: If the bed has manually or motorized adjustable bed ends, use the extended drive shaft supplied with this kit.

12.Replace the existing drive shaft with the extended drive shaft supplied with this kit.

13.Remove existing pull tube end in head motor assembly or head crank assembly and replace with the pull tube end furnished with this kit.

14.Reconnect pull tube end to head spring drive arm using the clevis and cotter pins. Refer to FIGURE 6.

FIGURE 6 - ATTACHING PULL TUBE END TO HEAD DRIVE ARM

15. Bed requires an 84-inch mattress.

NOTE: If assistance is required or any problems are encountered during the conversion, contact customer service at 1-800-333-6900

Invacare Corporation

www.invacare.com

 

 

 

 

USA

Canada

 

One Invacare Way

570 Matheson Blvd E Unit 8

Invacare is a registered trademark of

Elyria, Ohio USA

Mississauga Ontario

Invacare Corporation.

44036-2125

L4Z 4G4Canada

Yes, you can. is a trademark of Invacare

800-333-6900

800-668-5324

Corporation.

 

 

©2004 Invacare Corporation

 

 

Part No. 53000M701 Rev F 06/04

84-Inch Bed Extension

4

Part No. 53000M701

Page 4
Image 4
Invacare 5143IVC instruction sheet Attaching Pull Tube END to Head Drive ARM