Operating the Overbed Table
NOTE: For this procedure, refer to FIGURE 3.
Adjusting Table Height
1.Remove the transport screw.
2.Squeeze the height adjustable plate upward.
3.Push or pull the table top to the desired height.
CAUTION
Before taking the table apart, adjust the table to the lowest position and replace the transport screw, so the mast is locked before being packed and shipped.
Adjusting Table Angle - Model 6418 ONLY
1.Squeeze angle adjustable plate upward.
2.Tilt the table top down to the desired angle.
AngleAdjustable
Plate
Transport
Screw
Height
Adjustable
Plate
NOTE: Model 6418 shown. Height adjustable plate is located in the same place on model 6417.
FIGURE 3 Operating the Overbed Table - Adjusting Table Height - Adjusting Table Angle -
Model 6418 ONLY
Part No 1143201 | 3 | Deluxe Overbed Table |
